LM2 work with Evoscan

[starkers]

Can't seem to connect the LM2 to Evoscan, has anyone else tried and been successful:confused1:

I know there is not an option for it in the drop down menu ;)

[GrayW]

Not supported at present, email Hamish and ask if he intends on adding the protocol.

[starkers]

Will do :smile:

Keep using LogWorks3 until sorted then :blushing:

[evonut270]

How does it connect to the lm1 gray? Can't get mine to connect

[starkers]

How does it connect to the lm1 gray? Can't get mine to connect

Have you selected the LM1 on the Wideband drop down menu along the top and then gone to the top one which is something to do with detecting the com port?

[evonut270]

Yes mate but it only looks for com3 and usually when I connect up it's com16.it works fine with logworks

[starkers]

I'm still learning with LogWorks and not getting on too good with it hence was hoping evoscan would be compatible:blushing:

Strange you can't get your LM1 working with it:confused1:

[HermaN]

Yes mate but it only looks for com3 and usually when I connect up it's com16.it works fine with logworks

If it's looking for the LM-1 on COM 3, but the LM-1 is actually on COM 16, why not just change the COM port in device manager?

EvoScan will accept it through COM 1 - COM 7, so just change it under device manager from 16 to anything between 1 - 7.

[Leecavturbo]

If it's looking for the LM-1 on COM 3, but the LM-1 is actually on COM 16, why not just change the COM port in device manager?

EvoScan will accept it through COM 1 - COM 7, so just change it under device manager from 16 to anything between 1 - 7.

:thumbup1: