Safe to flash RA map?

[stu VI]

Would it be safe enough to flash a Ralliart map to my VI?

Assuming that I got my AFR checked at a dyno.

Cheers

[AndyF]

Yes, as long as it's checked afterwards however be aware that the Ralliart map on it's own won't really do a great deal as they are meant to be used with a boost increase.

Andy

[stu VI]

I've got an AVCR aswell Andy. What bar is safe to run at 1.5?

[GrayW]

You would need to check for det and AFR values, not advisable to just turn the boost up. Have you uprated the fuel pump?

[stu VI]

It has a walbro fitted. Was going to flash the RA rom then get it Dyno'd to check AFR and knock. Would this be safe enough?

[Cossie1]

1.5bar should be fine, you might find it's pretty good fueling wise (around 12.2 afr).

If you up the boost to 1.6bar, it will more than likely run a little richer.

[GrayW]

Just don't increase the boost till you have it on rollers and do it then. You can always log it after to check to see if you have any knock, or make some det cans.

[stu VI]

Just waiting for my Tactrix to come from the states. Is evoscan able to log the VI ecu yet?

[Cossie1]

Not yet, with the OP 2.0