Adding GM 3Bar MAP 8 ECU

[ko_racer]

Can any give me some help adding a GM 3 Bar MAP sensor to my ecu and logging it in evoscan?

I've got a Non MR FQ300 running the tephra 96260009 rom.

Obviously I need to get hold of a pin for the ecu from somewhere, any ideas where? Are there differences between the Evo 8 (260), Evo 8 FQ/JDM, Evo 9 Pins?

Run 5v from the 5v ecu pin to the MAP, run a 0v line, run a signal line from the MAP to ecu.

What would be the best pin to use? Would pin 92, as per the 9 ecu be ok?
How do I change the MUT table to look for this new sensor and give a useable reading?

Thanks

Keith