PDA

View Full Version : Wanted - 96260009 XML with Lean Spool

Jones the boost
22-01-2012, 12:15 PM
Anyone got the above as my XML doesnt give me any of the LS options?

Or is there another way of identifying if its enabled or not?
Aurélien
22-01-2012, 01:11 PM
<table name="Lean Spool Start RPM" category="Global Fuel Settings - Lean Spool" address="1680" type="1D" scaling="RPMStatLimit" />

<table name="Lean Spool Stop RPM" category="Global Fuel Settings - Lean Spool" address="1684" type="1D" scaling="RPMStatLimit" />

<table name="Lean Spool Trailing Time (Rich Side)" category="Global Fuel Settings - Lean Spool" address="392a" type="2D" level="2" scaling="uint8">
<table name="input value" address="5aee" type="Y Axis" elements="14" scaling="RPM" />
</table>

<table name="Lean Spool Trailing Time (Lean Side)" category="Global Fuel Settings - Lean Spool" address="393e" type="2D" level="2" scaling="uint8">
<table name="input value" address="5aee" type="Y Axis" elements="14" scaling="RPM" />
</table>

<table name="Min Temp for Lean Spool" category="Global Fuel Settings - Lean Spool" address="167e" type="1D" level="2" scaling="Temp" />

<table name="Lean Spool Enable Load Hysteresis" category="Global Fuel Settings - Lean Spool" address="167c" type="1D" level="2" scaling="Load16" />

<table name="Lean Spool AFR Mapping" category="Global Fuel Settings - Lean Spool" address="3966" type="2D" level="2" scaling="AFR">
<table name="base AFR" address="5b14" type="Y Axis" elements="7" scaling="AFR16" />
</table>

<table name="Lean Spool AFR below Enable" category="Global Fuel Settings - Lean Spool" address="1682" type="1D" level="2" scaling="AFR16" />

<table name="Lean Spool Clip Value" category="Global Fuel Settings - Lean Spool" address="1686" type="1D" level="2" scaling="AFR16" />
todd
22-01-2012, 04:50 PM
periphery 1 [0009 =on/0008=off] or periphery fba bits bit0 [off=0 /on=1]

or in lean spool settings set lean spool start/stop to the same 2500rpm
Jones the boost
22-01-2012, 05:08 PM
periphery 1 [0009 =on/0008=off] or periphery fba bits bit0 [off=0 /on=1]

or in lean spool settings set lean spool start/stop to the same 2500rpm

Nice one....just checked and its 0009/On :smile: