View Full Version : Evo 4 Flashing ?
HsamehH
07-07-2009, 03:43 AM
Hello,can i flash Evo 4 with open port 2 ?
thanks.
GrayW
07-07-2009, 05:45 AM
The IV ecu cannot be flashed.
HsamehH
07-07-2009, 01:24 PM
thanks for reply,but can i convert it to evo 5 + ecu ?
HsamehH
07-07-2009, 01:38 PM
also the car don't have port for the reflash connector only the open port connector :).
caesarson
07-07-2009, 01:47 PM
thanks for reply,but can i convert it to evo 5 + ecu ?
you can. Best try and get one from a VII thou. Hard to find. There was one from an 8 going for £60 on the MLR
AndyF
07-07-2009, 01:51 PM
also the car don't have port for the reflash connector only the open port connector :).You have to run a wire from pin79 on the ECU to the reflash connector and all is good :D
Andy
Racedude
21-07-2009, 12:11 PM
Hi Andy, a newbie here. So if I understand you correctly, I can plug in a e5 ecu to a e4 harness, run a wire from ecu pin 79 to the openport reflash connector and I'm good to go? Thanks for your time.
lee_r_one
21-07-2009, 12:20 PM
Correct
HsamehH
04-09-2009, 09:59 PM
sorry for bringing it up again but i need to know if i need to intercept wire between the stock harrness and the ecu for just a signal or just cut the wire coming from ecu and repin it to the reflash connector??
anttist
04-09-2009, 11:33 PM
You need to add pin and wire to ECU connector. Slot 79 is empty in Evo 4. For the other end you can use 2.5 mm stereo headphone plug which directly plugs into the Tactrix Openport 2.0 cable.
vBulletin® v3.8.7, Copyright ©2000-2012, vBulletin Solutions, Inc.